germafacts.blogg.se

Kel tec p 11 vs let tec p3at
Kel tec p 11 vs let tec p3at










IIRC, there's a LOT of direct P3AT/LCP comparison, over on the elsiepea forum ( ) (It's seen here, with the LCP's butt slightly raised, for illustration - it can be turned deeper in the waistband, out of sight) The belt clips are available in either a RH or LH version - the metal forming near the attachment differs. It cannot be readily seen, when wearing black pants/slacks. It installed in just about the time it took to tell you about it.

kel tec p 11 vs let tec p3at

I installed a KelTec belt/pocket clip on my LCP - ordered from Keltec, in fact ($11). I would opine that the difference was a function of the LCP's lighter poly frame, and slightly shorter barrel. The LCP is surprisingly loud, though - much louder/snappier than a. It's not a target pistol, and I didn't treat it as such - a magful was easily kept inside a man-size silly-wet during very rapid fire 7yds (about as far as I've ever expect to need to use it) Well - it didn't need any "break-in", since it was as bobble-free as my KelTec P32 has been for the last 10 years or so. I did, however ( on impulse ) buy one of the batch of new Ruger LCP's a local funshop had received ($269+tx) about 6 weeks ago, and have only put about 500 rounds of hardball and 40 rounds of JHP's through it so far, for break-in/practice. With Christmas on the doorstep, I didn't buy one( ($235+tx). It was "OK", and only slightly larger than my old P-32. I shot a P-3AT last Fall - but only breifly, for familiarization. Much different except for the firing works until you get to the Glocks. Ever think how few semiauto pistols aren't really just reworks of theġ911 and P-35 designs? Only the Walther locking block types (Ber 92) are really Look a LOT like a P3AT, so kinda hard to blame them TOO much. well, let's say even without actually copying anything, it would OTOH, if I were given the assignment by Ruger to design a super light CCW. SIMPLE is better, my P3AT works just fine. "lather over lawyers" with that one, but not certain it doesn't have extra tiny parts to Screw up/stick - no doubt failing in the SAFE position so you can't make it work.įor the LCP vs P3AT - more difficult to say, I don't think they got in such a Springs that will be a PITA to clean, so will not get cleaned much and will eventually I had to laugh at the PF-9 ripoff - thereĪre THREE extra safety systems in the gun adding 18 TINY little parts with micro Original innovative inventor or big company knock off? Ruger has done the












Kel tec p 11 vs let tec p3at